CANDLE CARE & BURNING GUIDE
 

CANDLES - GENERAL SAFETY

* PRIOR TO USE, REMOVE PRODUCT PACKAGING
* KEEP AWAY FROM COMBUSTIBLE MATERIALS
* KEEP AWAY FROM CHILDREN AND PETS
* BURN IN A DRAFT-FREE AREA
* KEEP WICK TRIMMED AT 1/4 IN OR AS DIRECTED BY THE MANUFACTURER
* BURN ON A LEVEL SURFACE
* KEEP MELT POOL FREE OF DEBRIS
* BURN WITHIN SIGHT AND NEVER LEAVE A BURNING CANDLE UNATTENDED!

3-WICK PILLAR DRIPS

Use on pillar plate

Refer to General Safety section above

Trim all wicks to ¼ inch and maintain this length throughout use. The best time to trim the wick is shortly after extinguishing it. Cutting the wick while it's still warm will prevent wick from breaking off. Because all of our wicks are 100% cotton, they become fragile once used. This is a normal. If you choose to trim the wick once it's cool, you can easily trim it using your nails. Careful not to cut the wick too short; if this happens, expose fresh wick by lighting the candle and allowing enough wax to melt around the wick. Pour the wax out and relight. Burn for a minimum of 2 hrs afterwards. 

All 3 wicks must be lit. Burn for minimum of 1.5 hrs to a maximum of 3 hrs at a time. This ensures that the wax pool has extended far enough and prevents candle from dripping along sides. Do not relight the candle until the wax is completely cool.

Hug the sides of your candle gently toward the center. Do this carefully as your candle is burning or right after extinguishing it. Be careful as liquid wax is hot! By gently folding the sides in during use, you extend your candle burn time as this avoids candle tunnelling. 

Extinguish the wick by dipping it into the wax pool.  You can use either a fork or a pair of tweezers to do this. By dipping the wick into the wax, you are re-priming your wick for the next burn and this also prevents re-lighting issues.

Troubleshooting


Thin Pillar Walls

If the walls of your pillar become too thin, the candle may begin to melt through the side and drip. This is generally caused by the wick being too long, creating a large flame or because the burn has extended beyond 2 hrs, the recommended burn time. Extinguish the candle, trim the wick, and let the wax cool and harden before relighting. 

Thick Pillar Walls

This may develop if the candle has bot been burning long enough each burning session. The recommended minimum burn time for our 3 wick pillar beeswax candles is 1.5 hrs. To correct thick pillar walls, heat a knife under hot water and carefully cut the walls down to the wax pool. Keep the cut wax to re-add to your candle afterwards. Burn for a minimum of 2 hrs. Slowly add bits of wax to the candle (instead of folding sides in).

Wick Won't Stay Lit

This can happen if the wick is cut too short. Expose fresh wick by lighting the candle and allowing enough wax to melt around the wick. Pour the wax out and relight. Burn for a minimum of 2 hrs afterwards. 

Wick Emitting Smoke

The wick is either too long and needs to be trimmed or the candle is exposed to a draft.